After replacing a 5816 wireless door/window contact on a Honeywell VISTA 20P, the new transmitter would not program into the panel. The system has a 6150RF keypad and a 6160 non-RF keypad.
Welcome!
Share and discuss the best content and new marketing ideas, build your professional profile and become a better marketer together.
This question has been flagged
1
Reply
3
Views
Cause: Two keypads were set to the same device address (16), which caused an address conflict and prevented the wireless transmitter from being programmed.
Fix:
- Review the keypad addresses in the panel's device programming and look for two keypads using the same address.
- Change the non-RF keypad (6160) to an unused address, for example from 16 to 17.
- Make sure the new address is enabled in the panel's device programming.
- Program the replacement 5816 transmitter into the desired wireless zone.
- Set the zone type to match the intended behavior, for example perimeter with instant alarm for a back door, rather than entry/exit.
- Open and close the door to test that the zone faults and restores at the keypad.
Need a hand with this? iknowpc's technicians can help - contact us.
Enjoying the discussion? Don't just read, join in!
Create an account today to enjoy exclusive features and engage with our awesome community!
Sign up